HPE FlexNetwork HSR6800 Configuration Manual page 351

Step
6. (Optional.) Set the source
UDP port number of ADVPN
packets.
7. Bind a VAM client to the
tunnel interface.
8. (Optional.) Configure a
private network for the tunnel
interface.
9. (Optional.) Set the keepalive
interval and the maximum
number of keepalive
attempts for the tunnel
interface.
10. (Optional.) Set the idle
timeout time for the
spoke-spoke tunnel.
11. (Optional.) Set the dumb
time for the tunnel interface.
12. (Optional.) Configure an
ADVPN group name.
Command
advpn source-port port-number
•
Bind an IPv4 VAM client to
the tunnel interface:
vam client client-name
[ compatible advpn0 ]
•
Bind an IPv6 VAM client to
the tunnel interface:
vam ipv6 client client-name
•
Configure a private IPv4
network for the tunnel
interface:
advpn network ip-address
{ mask-length | mask }
[ preference
preference-value ]
•
Configure a private IPv6
network for the tunnel
interface:
advpn ipv6 network prefix
prefix-length [ preference
preference-value ]
keepalive interval interval retry
retries
advpn session idle-time
time-interval
advpn session dumb-time
time-interval
advpn group group-name
338
Remarks
By default, the source UDP port
number of ADVPN packets is
18001.
This command is available when
the tunnel mode is UDP.
If the vam client command
configured on the tunnel interface
has the compatible keyword, the
tunnel interface must have a
different source UDP port number
than other tunnel interfaces.
By default, no VAM client is bound
to an ADVPN tunnel interface.
A VAM client can be bound to only
one IPv4 or IPv6 ADVPN tunnel
interface.
By default, no private network is
configured for the tunnel interface.
Set the preference of the private
network route to be higher than
other dynamic routing protocols,
and lower than static routing.
By default, the keepalive interval
is 180 seconds, and the maximum
number of keepalive attempts is 3.
The keepalive interval and the
maximum number of keepalive
attempts must be the same on the
tunnel interfaces in an ADVPN
domain.
By default, the idle timeout time is
600 seconds.
The new idle timeout setting
applies to both existing and
subsequently established
spoke-spoke tunnels.
By default, the dumb time is 120
seconds.
The new dumb time setting only
applies to subsequently
established tunnels.
By default, no ADVPN group
name is configured.
Perform this configuration on the
spoke.