Configuring Udp Helper To Convert Broadcast To Multicast - HPE FlexNetwork HSR6800 Configuration Manual

Step
5. Specify a destination
server for UDP helper to
convert broadcast to
unicast.
Configuring UDP helper to convert broadcast to
multicast
You can configure UDP helper to convert broadcast packets with specific UDP port numbers to
multicast packets.
Upon receiving a UDP broadcast packet, UDP helper uses the configured UDP ports to match the
UDP destination port number of the packet.
•
If a match is found, UDP helper duplicates the packet and modifies the destination IP address of
the copy to the configured multicast address. Then UDP helper forwards the packet to the
multicast group.
•
If no match is found, UDP helper does not process the packet.
To configure UDP helper to convert broadcast to multicast:
Step
1. Enter system view.
2. Enable UDP helper.
3. Specify a UDP port
number.
4. Enter interface view.
5. Specify a destination
multicast address for
UDP helper to convert
broadcast to multicast.
Command
udp-helper server ip-address [ global |
vpn-instance vpn-instance-name ]
Command
system-view
udp-helper enable
udp-helper port { port-number | dns |
netbios-ds | netbios-ns | tacacs | tftp |
time }
interface interface-type interface-number
udp-helper broadcast-map
multicast-address [ acl acl-number ]
195
Remarks
By default, no destination
server is specified.
If you specify multiple
destination servers, UDP
helper creates one copy for
each server.
Use this command on the
interface that receives
broadcast packets.
Remarks
N/A
By default, UDP helper is
disabled.
By default, no UDP port
numbers are specified.
N/A
By default, no destination
multicast address is specified
for UDP helper.
If you specify multiple multicast
addresses, UDP helper
creates one copy for each
address.
Use this command on the
interface that receives
broadcast packets.