HPE FlexNetwork HSR6800 Configuration Manual page 178

[Router] interface gigabitethernet 2/1/2
[Router-GigabitEthernet2/1/2] nat outbound port-block-group 1
[Router-GigabitEthernet2/1/2] quit
Verifying the configuration
# Verify that users at the private IP addresses can access the Internet. (Details not shown.)
# Display all NAT configuration and statistics.
[Router] display nat all
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL
Config status: Active
...
NAT port block group information:
Totally 1 NAT port block groups.
Port block group 1:
Port range: 10001-15000
Block size: 500
Local IP address information:
Start address
10.110.10.1
Global IP pool information:
Start address
202.38.1.100
NAT outbound port block group information:
Totally 1 outbound port block group items.
Interface: GigabitEthernet2/1/2
Port block group: 1
Config status
# Display static NAT444 mappings.
[Router] display nat port-block static
Static port-block mapping tables:
Local VPN
---
---
---
---
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: ---
End address
10.110.10.10
End address
202.38.1.100
: Active
Local IP Global IP
10.110.10.1 202.38.1.100
10.110.10.2 202.38.1.100
10.110.10.3 202.38.1.100
10.110.10.4 202.38.1.100
VPN instance
---
Port block
10001-10500
10501-11000
11001-11500
11501-12000
165
Connections
2
0
0
0