HPE FlexNetwork HSR6800 Configuration Manual page 386
Comware 7 layer 3, ip services
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (482 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub private-address 192.168.0.2
[PrimaryServer-vam-server-domain-abc-hub-group-0] hub private-address 192.168.0.3
[PrimaryServer-vam-server-domain-abc-hub-group-0] quit
# Create hub group 1.
[PrimaryServer-vam-server-domain-abc] hub-group 1
# Specify hub private IPv4 addresses.
[PrimaryServer-vam-server-domain-abc-hub-group-1] hub private-address 192.168.1.1
[PrimaryServer-vam-server-domain-abc-hub-group-1] hub private-address 192.168.1.2
# Specify a spoke private IPv4 network.
[PrimaryServer-vam-server-domain-abc-hub-group-1] spoke private-address network
192.168.1.0 255.255.255.0
# Allow establishing direct spoke-spoke tunnels.
[PrimaryServer-vam-server-domain-abc-hub-group-1] shortcut interest all
[PrimaryServer-vam-server-domain-abc-hub-group-1] quit
# Create hub group 2.
[PrimaryServer-vam-server-domain-abc] hub-group 2
# Specify the hub private IPv4 address.
[PrimaryServer-vam-server-domain-abc-hub-group-2] hub private-address 192.168.2.1
# Specify a spoke private IPv4 network.
[PrimaryServer-vam-server-domain-abc-hub-group-2] spoke private-address network
192.168.2.0 255.255.255.0
# Allow establishing direct spoke-spoke tunnels.
[PrimaryServer-vam-server-domain-abc-hub-group-2] shortcut interest all
[PrimaryServer-vam-server-domain-abc-hub-group-2] quit
# Set the pre-shared key to 123456.
[PrimaryServer-vam-server-domain-abc] pre-shared-key simple 123456
# Set the authentication mode to CHAP.
[PrimaryServer-vam-server-domain-abc] authentication-method chap
# Enable the VAM server for the ADVPN domain.
[PrimaryServer-vam-server-domain-abc] server enable
[PrimaryServer-vam-server-domain-abc] quit
Configuring the secondary VAM server
# Configure the secondary VAM server in the same way that the primary server is configured.
(Details not shown.)
Configuring Hub 1
1.
Configure IP addresses for the interfaces. (Details not shown.)
2.
Configure the VAM client:
# Create VAM client Hub1Group0.
<Hub1> system-view
[Hub1] vam client name Hub1Group0
# Specify ADVPN domain abc for the VAM client.
[Hub1-vam-client-Hub1Group0] advpn-domain abc
# Set the pre-shared key to 123456.
[Hub1-vam-client-Hub1Group0] pre-shared-key simple 123456
# Set both the username and password to hub1.
[Hub1-vam-client-Hub1Group0] user hub1 password simple hub1
373
Advertisement
Table of Contents
Troubleshooting
