HPE FlexNetwork HSR6800 Configuration Manual page 172

Comware 7 layer 3, ip services

Hide thumbs Also See for FlexNetwork HSR6800:

Table of Contents

Interfaces enabled with static NAT:

Totally 2 interfaces enabled with static NAT.

Interface: GigabitEthernet2/1/1

Config status: Active

Interface: GigabitEthernet2/1/2

Config status: Active

NAT logging:

Port-block-assign

Port-block-withdraw : Disabled

NAT mapping behavior:

Mapping mode : Address and Port-Dependent

Config status: Active

# Display NAT session information generated when Host A accesses Host B.

[Router] display nat session verbose

IP/port: 192.168.1.2/42496

Destination IP/port: 172.16.2.2/2048

DS-Lite tunnel peer: -

VPN instance/VLAN ID/Inline ID: vpn1/-/-

Protocol: ICMP(1)

Inbound interface: GigabitEthernet2/1/1

IP/port: 192.168.1.2/42496

Destination IP/port: 172.16.1.2/0

DS-Lite tunnel peer: -

VPN instance/VLAN ID/Inline ID: vpn2/-/-

Protocol: ICMP(1)

Inbound interface: GigabitEthernet2/1/2

State: ICMP_REPLY

Application: INVALID

Start time: 2012-08-16 09:30:49

Initiator->Responder:

Responder->Initiator:

Total sessions found: 1

Troubleshooting