HPE FlexNetwork HSR6800 Configuration Manual page 377

Figure 142 Network diagram
Table 14 Interface and IP address assignment
Device
Hub 1
Hub 2
AAA server
Primary server
Secondary server
Configuring the primary VAM server
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure AAA:
# Configure RADIUS scheme abc.
<PrimaryServer> system-view
[PrimaryServer] radius scheme abc
[PrimaryServer-radius-abc] primary authentication ipv6 1::10 1812
[PrimaryServer-radius-abc] primary accounting ipv6 1::10 1813
[PrimaryServer-radius-abc] key authentication simple 123
[PrimaryServer-radius-abc] key accounting simple 123
[PrimaryServer-radius-abc] user-name-format without-domain
[PrimaryServer-radius-abc] quit
[PrimaryServer] radius session-control enable
# Configure AAA methods for ISP domain abc.
[PrimaryServer] domain abc
Interface IP address
GE2/1/1 1::1/64
Tunnel1 192:168::1/64
GE2/1/1 1::2/64
Tunnel1 192:168::2/64
1::10/64
GE2/1/1 1::11/64
GE2/1/1 1::12/64
Device
Spoke 1
Spoke 2
364
Interface IP address
GE2/1/1 1::3/64
GE2/1/2 192:168:1::1/64
Tunnel1 192:168::3/64
GE2/1/1 1::4/64
GE2/1/2 192:168:2::1/64
Tunnel1 192:168::4/64