Configuring Ipv6 Prefix Acquisition; Configuring Ipv6 Address And Prefix Acquisition; Configuring Stateless Dhcpv6 - HPE FlexNetwork HSR6800 Configuration Manual

Step
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 address and other
configuration parameters.

Configuring IPv6 prefix acquisition

Step
1. Enter system view.
2. Enter Layer 3 interface view.
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 prefix and other
configuration parameters.

Configuring IPv6 address and prefix acquisition

Step
1. Enter system view.
2. Enter Layer 3 interface view.
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 address, an IPv6 prefix,
and other configuration
parameters.

Configuring stateless DHCPv6

Step
1. Enter system view.
2. Enter Layer 3 interface
view.
3. Configure the interface to
support stateless DHCPv6.
Command
ipv6 address dhcp-alloc
[ option-group group-number |
rapid-commit ] *
Command
system-view
interface interface-type
interface-number
ipv6 dhcp client pd
prefix-number [ option-group
group-number | rapid-commit ] *
Command
system-view
interface interface-type
interface-number
ipv6 dhcp client stateful prefix
prefix-number [ option-group
option-group-number |
rapid-commit ] *
Command
system-view
interface interface-type
interface-number
•
Enable stateless IPv6 address
autoconfiguration:
ipv6 address auto
•
Enable stateless DHCPv6:
ipv6 dhcp client stateless
enable
262
Remarks
By default, the interface does not
use DHCPv6 for IPv6 address
acquisition.
Remarks
N/A
N/A
By default, the interface does not
use DHCPv6 for IPv6 prefix
acquisition.
Remarks
N/A
N/A
By default, the interface does not
use DHCPv6 for IPv6 address and
prefix acquisition.
Remarks
N/A
N/A
By default, the interface does not
support stateless DHCPv6.
You can perform both tasks.
If you use only the ipv6 address
auto command, make sure the
M flag is set to 0 and the O flag is
set to 1 in the RA message.
Otherwise, stateless DHCPv6
cannot be triggered.