Nat Server For External-To-Internal Access Configuration Example - HPE FlexNetwork HSR6800 Configuration Manual
Comware 7 layer 3, ip services
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (482 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL
Config status: Active
NAT ALG:
DNS
...
# Display NAT session information generated when Host A accesses the Web server.
[Router] display nat session verbose
Initiator:
Source
Destination IP/port: 202.38.1.2/8080
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: TCP(6)
Inbound interface: GigabitEthernet2/1/1
Responder:
Source
Destination IP/port: 202.38.1.3/1025
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: TCP(6)
Inbound interface: GigabitEthernet2/1/2
State: TCP_ESTABLISHED
Application: HTTP
Start time: 2012-08-15 14:53:29
Initiator->Responder:
Responder->Initiator:
Total sessions found: 1
NAT Server for external-to-internal access configuration
example
Network requirements
As shown in
network to provide services for external users. The internal network address is 10.110.0.0/16. The
company has three public IP addresses from 202.38.1.1/24 to 202.38.1.3/24.
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: ---
: Enabled
IP/port: 192.168.1.10/1694
IP/port: 192.168.1.10/8080
Figure
60, two Web servers, one FTP server and one SMTP server are in the internal
TTL: 3597s
7 packets
308 bytes
5 packets
312 bytes
144
Advertisement
Table of Contents
Troubleshooting
