Ipv4 Hub-Spoke Advpn Configuration Example - HPE FlexNetwork HSR6800 Configuration Manual

56 bytes from 192:168::4, icmp_seq=2 hlim=64 time=1.000 ms
56 bytes from 192:168::4, icmp_seq=3 hlim=64 time=1.000 ms
56 bytes from 192:168::4, icmp_seq=4 hlim=64 time=1.000 ms
--- Ping6 statistics for 192:168::4 ---
5 packets transmitted, 5 packets received, 0.0% packet loss
round-trip min/avg/max/std-dev = 0.000/1.200/3.000/0.980 ms
# Display IPv6 ADVPN tunnel information on Spokes. This example uses Spoke 1.
[Spoke1] display advpn ipv6 session
Interface
Number of sessions: 3
Private address
192:168::1
192:168::2
192.168::4
The output shows the following information:
•
Spoke 1 has established a permanent hub-spoke tunnel to Hub 1 and Hub 2.
•
Spoke 1 has established a temporary spoke-spoke tunnel to Spoke 2.

IPv4 hub-spoke ADVPN configuration example

Network requirements
As shown in
information for all hubs and spokes. The AAA server performs authentication and accounting for
VAM clients. The two hubs back up each other, and perform data forwarding and route exchange.
Establish a permanent ADVPN tunnel between each spoke and each hub.
Figure 141 Network diagram
: Tunnel1
Public address
1::1
1::2
1::4
Figure 141, the primary and secondary VAM servers manage and maintain VAM client
Port Type State
-- S-H Success
-- S-H Success
-- S-S Success
356
Holding time
0H 46M 8S
0H 46M 8S
0H 0M 1S