Stateless Dhcpv6 Configuration Example - HPE FlexNetwork HSR6800 Configuration Manual

# Display information about the dynamic IPv6 prefix. The output shows that the client has obtained
an IPv6 prefix.
[Router] display ipv6 prefix 1
Number: 1
Type : Dynamic
Prefix: 12:34::/48
Preferred lifetime 100 sec, valid lifetime 200 sec
# After DHCPv6 server is enabled on the device, display information about the dynamic DHCPv6
option group. The output shows that a dynamic DHCPv6 option group exists for saving configuration
parameters.
[Router] display ipv6 dhcp option-group 1
DHCPv6 option group: 1
DNS server addresses:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: GigabitEthernet2/1/1
2000::FF
Domain name:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: GigabitEthernet2/1/1
example.com
SIP server addresses:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: GigabitEthernet2/1/1
2:2::4
SIP server domain names:
Type: Dynamic (DHCPv6 address and prefix allocation)
Interface: GigabitEthernet2/1/1
bbb.com

Stateless DHCPv6 configuration example

Network requirements
As shown in
obtain configuration parameters except IPv6 address and IPv6 prefix. Router B acts as the gateway
and advertises RA messages periodically.
Figure 106 Network diagram
Configuration procedure
You must configure the DHCPv6 server before configuring the DHCPv6 client. For information about
configuring the DHCPv6 server, see
1. Configure the gateway Router B:
Figure 106, configure GigabitEthernet 2/1/1 on Router A to use stateless DHCPv6 to
"Configuring the DHCPv6
269
server."