Ipv4-Initiated Communication; Enabling Aft; Configuring An Ipv6-To-Ipv4 Destination Address Translation Policy - HPE FlexNetwork HSR6800 Configuration Manual

Task at a glance
(Required.)
(Optional.)
(Optional.)

IPv4-initiated communication

Task at a glance
(Required.)
(Required.)
(Required.)
(Optional.)
(Optional.)

Enabling AFT

To implement address translation between IPv4 and IPv6 networks, you must enable AFT on
interfaces connected to the IPv4 network and interfaces connected to the IPv6 network.
To enable AFT:
Step
1. Enter system view.
2. Enter interface view.
3. Enable AFT.
Configuring an IPv6-to-IPv4 destination address
translation policy
AFT compares an IPv6 packet with IPv6-to-IPv4 destination address translation policies in the
following order:
1. IPv4-to-IPv6 source address static mappings.
2. General prefixes.
3. NAT64 prefixes.
To configure an IPv6-to-IPv4 destination address translation policy:
Step
1. Enter system view.
Configuring an IPv6-to-IPv4 source address translation policy
Configuring AFT logging
Setting the ToS field to 0 for translated IPv4 packets
Enabling AFT
Configuring an IPv4-to-IPv6 destination address translation policy
Configuring an IPv4-to-IPv6 source address translation policy
Configuring AFT logging
Setting the Traffic Class field to 0 for translated IPv6 packets
Command
system-view
interface interface-type
interface-number
aft enable
Command
system-view
412
Remarks
N/A
N/A
By default, AFT is disabled.
Remarks
N/A