Ipv6 Nd Suppression Configuration Example - HPE FlexNetwork HSR6800 Configuration Manual

OutForwDatagrams:
InNoRoutes:
InTooBigErrors:
OutFragOKs:
OutFragCreates:
InMcastPkts:
InMcastNotMembers:
OutMcastPkts:
InAddrErrors:
InDiscards:
OutDiscards:
# Ping Router A and Router B from the host, and ping Router A and the host from Router B to verify
that they can reach each other.
NOTE:
To ping a link-local address, use the –i parameter to specify an interface for the link-local address.
[RouterB] ping ipv6 -c 1 3001::1
Ping6(56 data bytes) 3001::2 --> 3001::1, press CTRL_C to break
56 bytes from 3001::1, icmp_seq=0 hlim=64 time=4.404 ms
--- Ping6 statistics for 3001::1 ---
1 packet(s) transmitted, 1 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 4.404/4.404/4.404/0.000 ms
[RouterB] ping ipv6 -c 1 2001::15B:E0EA:3524:E791
Ping6(56 data bytes) 3001::2 --> 2001::15B:E0EA:3524:E791, press CTRL_C to break
56 bytes from 2001::15B:E0EA:3524:E791, icmp_seq=0 hlim=64 time=5.404 ms
--- Ping6 statistics for 2001::15B:E0EA:3524:E791 ---
1 packet(s) transmitted, 1 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 5.404/5.404/5.404/0.000 ms
The output shows that Router B can ping Router A and the host. The host can also ping Router B and
Router A (output not shown).

IPv6 ND suppression configuration example

Network requirements
As shown in
station can reach the L3VE interface L3VE1 of Router B.
Enable IPv6 ND suppression on Router A to directly answer ND messages for Router B.
Figure 88 Network diagram
Base station
GE2/1/1
2001::1/64
Figure 88, the base station, Router A, and Router B are in an MPLS L2VPN. The base
Router A
GE2/1/1
2001::2/64
0
0
0
0
0
28
0
7
0
0
0
Router B
GE2/1/2 GE2/1/2
1::1/64 1::2/64
231
L3VE1
2001::3/64