HPE FlexNetwork HSR6800 Configuration Manual page 298

Figure 115 Network diagram
Configuration procedure
Make sure Router A and Router B can reach each other through IPv4.
•
Configure Router A:
# Specify an IPv4 address for GigabitEthernet 2/1/2.
<RouterA> system-view
[RouterA] interface gigabitethernet 2/1/2
[RouterA-GigabitEthernet2/1/2] ip address 192.168.100.1 255.255.255.0
[RouterA-GigabitEthernet2/1/2] quit
# Specify an IPv6 address for GigabitEthernet 2/1/1.
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ipv6 address 3002::1 64
[RouterA-GigabitEthernet2/1/1] quit
# Create the IPv6 over IPv4 manual tunnel interface Tunnel 0.
[RouterA] interface tunnel 0 mode ipv6-ipv4
# Specify an IPv6 address for the tunnel interface.
[RouterA-Tunnel0] ipv6 address 3001::1/64
# Specify GigabitEthernet 2/1/2 as the source interface of the tunnel interface.
[RouterA-Tunnel0] source gigabitethernet 2/1/2
# Specify the destination address for the tunnel interface as the IP address of GigabitEthernet
2/1/2 on Router B.
[RouterA-Tunnel0] destination 192.168.50.1
[RouterA-Tunnel0] quit
# Configure a static route destined for IPv6 network 2 through Tunnel 0.
[RouterA] ipv6 route-static 3003:: 64 tunnel 0
•
Configure Router B:
# Specify an IPv4 address for GigabitEthernet 2/1/2.
<RouterB> system-view
[RouterB] interface gigabitethernet 2/1/2
[RouterB-GigabitEthernet2/1/2] ip address 192.168.50.1 255.255.255.0
[RouterB-GigabitEthernet2/1/2] quit
# Specify an IPv6 address for GigabitEthernet 2/1/1.
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] ipv6 address 3003::1 64
[RouterB-GigabitEthernet2/1/1] quit
# Create the IPv6 over IPv4 manual tunnel interface Tunnel 0.
[RouterB] interface tunnel 0 mode ipv6-ipv4
# Specify an IPv6 address for the tunnel interface.
285