Outbound Dynamic Nat Configuration Example (Non-Overlapping Addresses) - HPE FlexNetwork HSR6800 Configuration Manual
Comware 7 layer 3, ip services
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (482 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Interfaces enabled with static NAT:
Totally 1 interfaces enabled with static NAT.
Interface: GigabitEthernet2/1/2
Config status: Active
# Display NAT session information.
[Router] display nat session verbose
Initiator:
Source
Destination IP/port: 202.38.1.111/2048
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: ICMP(1)
Inbound interface: GigabitEthernet2/1/1
Responder:
Source
Destination IP/port: 202.38.1.100/0
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: ICMP(1)
Inbound interface: GigabitEthernet2/1/2
State: ICMP_REPLY
Application: INVALID
Start time: 2012-08-16 09:30:49
Initiator->Responder:
Responder->Initiator:
Total sessions found: 1
Outbound dynamic NAT configuration example
(non-overlapping addresses)
Network requirements
As shown in
addresses 202.38.1.2 and 202.38.1.3. Configure outbound dynamic NAT to allow only internal users
on subnet 192.168.1.0/24 to access the Internet.
Figure 58 Network diagram
IP/port: 10.110.10.8/42496
IP/port: 202.38.1.111/42496
Figure
58, a company has a private address 192.168.0.0/16 and two public IP
TTL: 27s
5 packets
420 bytes
5 packets
420 bytes
139
Advertisement
Table of Contents
Troubleshooting
