HPE FlexNetwork HSR6800 Configuration Manual page 211
Comware 7 layer 3, ip services
Hide thumbs
Also See for FlexNetwork HSR6800:
- Security command reference (538 pages) ,
- Configuration manual (482 pages) ,
- Command reference manual (153 pages)
Table of Contents
Advertisement
Figure 75 Network diagram
Configuration procedure
Make sure Router A can reach the subnet 10.2.0.0/16.
# Enable UDP helper.
<RouterA> system-view
[RouterA] udp-helper enable
# Enable the UDP port 55 for UDP helper.
[RouterA] udp-helper port 55
# Configure UDP helper to convert broadcast packets to multicast packets destined for 225.1.1.1 on
GigabitEthernet 2/1/1.
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] ip address 10.110.1.1 16
[RouterA-GigabitEthernet2/1/1] udp-helper broadcast-map 225.1.1.1
[RouterA-GigabitEthernet2/1/1] quit
# Enable IP multicast routing globally.
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable PIM-DIM and IGMP on GigabitEthernet 2/1/1.
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] pim dm
[RouterA-GigabitEthernet2/1/1] igmp enable
# Configure GigabitEthernet 2/1/1 as a static member of the multicast group 225.1.1.1.
[RouterA-GigabitEthernet2/1/1] igmp static-group 225.1.1.1
# Enable PIM-DIM and IGMP on GigabitEthernet 2/1/2.
[RouterA-GigabitEthernet2/1/2] pim dm
[RouterA-GigabitEthernet2/1/2] igmp enable
# Configure GigabitEthernet 2/1/2 as a static member of the multicast group 225.1.1.1.
[RouterA-GigabitEthernet2/1/2] igmp static-group 225.1.1.1
Verifying the configuration
Verify that you can capture multicast packets from Router A on Router B.
198
Advertisement
Table of Contents
Troubleshooting
