Enabling Dhcp; Enabling The Dhcp Relay Agent On An Interface - HPE FlexNetwork HSR6800 Configuration Manual

Tasks at a glance
(Optional.) Configuring the DHCP relay agent to release an IP address
(Optional.) Configuring Option 82
(Optional.) Setting the DSCP value for DHCP packets sent by the DHCP relay agent
(Optional.) Enabling DHCP server proxy on a DHCP relay agent
(Optional.) Configuring a DHCP relay address pool
(Optional.) Specifying a gateway address for DHCP clients
(Optional.) Enabling client offline detection on the DHCP relay agent
(Optional.) Configuring the DHCP smart relay feature
(Optional.) Specifying the source IP address for relayed DHCP requests
(Optional.) Configuring the DHCP relay agent to forward DHCP replies based on Option 82

Enabling DHCP

You must enable DHCP to validate other DHCP relay agent settings.
To enable DHCP:
Step
1. Enter system view.
2. Enable DHCP.

Enabling the DHCP relay agent on an interface

With the DHCP relay agent enabled, an interface forwards incoming DHCP requests to a DHCP
server.
An IP address pool that contains the IP address of the DHCP relay interface must be configured on
the DHCP server. Otherwise, the DHCP clients connected to the relay agent cannot obtain correct IP
addresses.
To enable the DHCP relay agent on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Enable the DHCP relay
agent.
Command
system-view
dhcp enable
Command
system-view
interface interface-type
interface-number
dhcp select relay
65
Remarks
N/A
By default, DHCP is disabled.
Remarks
N/A
N/A
By default, when DHCP is
enabled, an interface operates in
the DHCP server mode.