HPE FlexNetwork HSR6800 Configuration Manual page 344

Step
1. Enter system view.
2. Enter ADVPN domain view.
3. Enter hub group view.
4. Configure a hub private
address.
Configuring a spoke private address range in a hub group
You can configure multiple spoke private address ranges in a hub group. The ranges are listed from
low to high.
To configure a spoke private address range in a hub group:
Step
1. Enter system view.
2. Enter ADVPN domain view.
3. Enter hub group view.
4. Configure a spoke private
address range.
Specifying an ACL to control establishing spoke-to-spoke tunnels
The VAM server assigns the specified ACL to an online hub. The hub uses the ACL to match
received packets. If a match is found, the hub sends a redirect packet to the spoke that sent the
packet. Then, the spoke sends the VAM server the destination address of the packet, obtains the
remote spoke information, and establishes a direct tunnel to the remote spoke.
To specify an ACL to control establishing spoke-to-spoke tunnels:
Command
system-view
vam server advpn-domain
domain-name [ id domain-id ]
hub-group group-name
•
Configure a hub private IPv4
address:
hub private-address
private-ip-address
[ public-address
{ public-ip-address |
public-ipv6-address }
[ advpn-port port-number ] ]
•
Configure a hub private IPv6
address:
hub ipv6 private-address
private-ipv6-address
[ public-address
{ public-ip-address |
public-ipv6-address }
[ advpn-port port-number ] ]
Command
system-view
vam server advpn-domain
domain-name [ id domain-id ]
hub-group group-name
•
Configure a spoke private IPv4
address range:
spoke private-address
{ network ip-address
{ mask-length | mask } | range
start-address end-address }
•
Configure a spoke private IPv6
address range:
spoke ipv6 private-address
{ network prefix prefix-length |
range start-ipv6-address
end-ipv6-address }
331
Remarks
N/A
N/A
N/A
Use either command.
By default, no hub private
address is configured.
Remarks
N/A
N/A
N/A
Use either command.
By default, no spoke private
address range is configured.