Displaying The Adjacency Table - HPE FlexNetwork HSR6800 Configuration Manual

Displaying the adjacency table

The adjacency table stores information about directly connected neighbors for IP forwarding. The
neighbor information in this chapter refers to non-Ethernet neighbor information.
This table is not user configurable. The neighbor information is generated, updated, and deleted by
link layer protocols through negotiation (such as PPP dynamic negotiation) or through manual
configuration. An adjacency entry includes the following information:
•
Neighbor network layer address (next hop).
•
Output interface.
•
Link layer protocol type.
•
Link layer address.
When forwarding an IP packet, the device performs the following tasks:
•
Searches the FIB to find the output interface and next hop.
•
Uses the output interface and next hop address to search the adjacency table for link layer
forwarding information.
NOTE:
Ethernet and non-Ethernet neighbor information are stored and managed together.
The following table shows the items in an adjacency table output:
Item
IP address
IPv6 address
Routing interface
Physical interface
Logical interface
Service type
Action type
Link media type
Link head information(IP)
Link head information(IPv6)
Link head
information(MPLS)
To display adjacency table entries, use one of the following commands in any view:
Description
IP address of the next hop in the FIB table. This address is used for
adjacency table lookup.
IPv6 address of the next hop in the FIB table. This address is used for
adjacency table lookup.
Output interface in the matching route entry. This interface is used for
adjacency table lookup, and it can be logical or physical.
Output physical interface that sends matching packets.
•
If the routing interface is physical, the routing interface and physical
interface are the same.
•
If the routing interface is logical, the routing interface and physical
interface are different.
Logical interface for sending packets, such as a Virtual-Template interface
for MP.
Link layer protocol type, such as PPP or HDLC.
Action to be taken on the matching packet: Forwarding or Drop.
Related to the link layer protocol used by the routing interface.
•
P2P—Point-to-point link.
•
NBMA—Non-broadcast multi-access link.
Link layer header for IP forwarding.
Link layer header for IPv6 forwarding.
Link layer header for MPLS forwarding.
179