HPE FlexNetwork HSR6800 Configuration Manual page 165

Port-preserved: N
Config status: Active
NAT internal server information:
Totally 1 internal servers.
Interface: GigabitEthernet2/1/2
Protocol: 17(UDP)
Global IP/port: 202.38.1.4/53
Local IP/port : 200.1.1.3/53
Config status : Active
NAT logging:
Log enable
Flow-begin
Flow-end
Flow-active
Port-block-assign
Port-block-withdraw : Disabled
Alarm
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL : ---
Config status: Active
NAT ALG:
DNS : Enabled
...
# Display NAT session information generated when Host accesses the Web server.
[Router] display nat session verbose
Initiator:
Source IP/port: 192.168.1.2/1694
Destination IP/port: 202.38.1.2/8080
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: TCP(6)
Inbound interface: GigabitEthernet2/1/2
Responder:
Source IP/port: 192.168.1.2/8080
Destination IP/port: 202.38.1.3/1025
DS-Lite tunnel peer: -
VPN instance/VLAN ID/Inline ID: -/-/-
Protocol: TCP(6)
Inbound interface: GigabitEthernet2/1/1
State: TCP_ESTABLISHED
Application: HTTP
Start time: 2012-08-15 14:53:29
Initiator->Responder:
NO-PAT: Y
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
: Disabled
TTL: 3597s
7 packets
152
Reversible: Y
308 bytes