Enabling Ip Conflict Notification - HPE FlexNetwork HSR6800 Configuration Manual

Enabling IP conflict notification

By default, if the sender IP address of an incoming ARP packet is the same as that of the device, the
device sends a gratuitous ARP request. The device displays an error message only after it receives
an ARP reply about the conflict.
You can use this command to enable the device to display error messages before sending a
gratuitous ARP reply or request for conflict confirmation.
To enable IP conflict notification:
Step
1. Enter system view.
2. Enable IP conflict
notification.
Command
system-view
arp ip-conflict log prompt
10
Remarks
N/A
By default, IP conflict notification is
disabled.