Tunneling Configuration Task List; Configuring A Tunnel Interface - HPE FlexNetwork HSR6800 Configuration Manual

Tunneling configuration task list

Tasks at a glance
(Required.)
Perform one of the following tasks:
•
Configuring an IPv6 over IPv4 tunnel:
Configuring an IPv6 over IPv4 manual tunnel
Configuring an automatic IPv4-compatible IPv6 tunnel
Configuring a 6to4 tunnel
Configuring an ISATAP tunnel
•
Configuring an IPv4 over IPv4 tunnel
•
Configuring an IPv4 over IPv6 tunnel:
Configuring an IPv4 over IPv6 manual tunnel
Configuring a DS-Lite tunnel
•
Configuring an IPv6 over IPv6 tunnel

Configuring a tunnel interface

Configure a tunnel interface (Layer 3 virtual interface) on the devices at both ends of a tunnel. The
devices use the tunnel interface to identify, process, and send packets for the tunnel.
When an active/standby switchover occurs or the standby MPU is removed, the tunnel interfaces
configured on the active or standby MPU still exist. To delete a tunnel interface, use the undo
interface tunnel command.
To configure a tunnel interface:
Step
1. Enter system view.
2. Create a tunnel interface,
specify the tunnel mode, and
enter tunnel interface view.
3. (Optional.) Configure a
description for the interface.
4. (Optional.) Specify a primary
traffic processing slot for the
tunnel interface.
Configuring a tunnel interface
Command
system-view
interface tunnel number [ mode
{ advpn { gre | udp } [ ipv6 ] |
ds-lite-aftr | evi | gre [ ipv6 ] |
ipv4-ipv4 | ipv4-ipv6 | ipv6-ipv4
[ 6to4 | auto-tunnel | isatap ] |
ipv6-ipv6 | mpls-te | vxlan } ]
description text
•
In standalone mode:
service slot slot-number
•
In IRF mode:
service chassis
chassis-number slot
slot-number
282
Remarks
N/A
By default, no tunnel interfaces
exist.
When you create a new tunnel
interface, you must specify the
tunnel mode. When you enter
the view of an existing tunnel
interface, you do not need to
specify the tunnel mode.
For packet tunneling to succeed,
the two ends of a tunnel must
use the same tunnel mode.
By default, the description for a
tunnel interface is Tunnel
number Interface.
By default, no primary traffic
processing slot is specified for
an interface.