HPE FlexNetwork HSR6800 Configuration Manual page 307

Figure 119 Network diagram
Configuration procedure
•
Configure the router:
# Specify an IPv6 address for GigabitEthernet 2/1/2.
<Router> system-view
[Router] interface gigabitethernet 2/1/2
[Router-GigabitEthernet2/1/2] ipv6 address 3001::1/64
[Router-GigabitEthernet2/1/2] quit
# Specify an IPv4 address for GigabitEthernet 2/1/1.
[Router] interface gigabitethernet 2/1/1
[Router-GigabitEthernet2/1/1] ip address 1.1.1.1 255.0.0.0
[Router-GigabitEthernet2/1/1] quit
# Create the ISATAP tunnel interface Tunnel 0.
[Router] interface tunnel 0 mode ipv6-ipv4 isatap
# Specify an EUI-64 IPv6 address for the tunnel interface.
[Router-Tunnel0] ipv6 address 2001:: 64 eui-64
# Specify GigabitEthernet 2/1/1 as the source interface of the tunnel interface.
[Router-Tunnel0] source gigabitethernet 2/1/1
# Disable RA suppression so that the ISATAP host can acquire information such as the address
prefix from the RA message advertised by the ISATAP router.
[Router-Tunnel0] undo ipv6 nd ra halt
[Router-Tunnel0] quit
•
Configure the ISATAP host:
Configurations on the ISATAP host vary by operating system. The following configuration is
performed on Windows XP.
# Install IPv6.
C:\>ipv6 install
# On a host running Windows XP, the ISATAP interface is typically interface 2. Display
information about the ISATAP interface.
C:\>ipv6 if 2
Interface 2: Automatic Tunneling Pseudo-Interface
Guid {48FCE3FC-EC30-E50E-F1A7-71172AEEE3AE}
does not use Neighbor Discovery
does not use Router Discovery
routing preference 1
EUI-64 embedded IPv4 address: 0.0.0.0
router link-layer address: 0.0.0.0
preferred link-local fe80::5efe:1.1.1.2, life infinite
link MTU 1280 (true link MTU 65515)
294