Configuring Ipv6 Static Routing; Configuring An Ipv6 Static Route; Configuring Bfd For Ipv6 Static Routes - HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Manual

Configuring IPv6 static routing

Static routes are manually configured and cannot adapt to network topology changes. If a fault or a
topological change occurs in the network, the network administrator must modify the static routes
manually. IPv6 static routing works well in a simple IPv6 network.

Configuring an IPv6 static route

Before you configure an IPv6 static route, complete the following tasks:
•
Configure parameters for the related interfaces.
•
Configure link layer attributes for the related interfaces.
•
Make sure the neighboring nodes can reach each other.
To configure an IPv6 static route:
Step
Enter system view.
1.
Configure an IPv6 static
2.
route.
(Optional.) Configure the
3.
default preference for
IPv6 static routes.
(Optional.) Delete all IPv6
4.
static routes, including
the default route.

Configuring BFD for IPv6 static routes

BFD provides a general purpose, standard, and medium- and protocol-independent fast failure
detection mechanism. It can uniformly and quickly detect the failures of the bidirectional forwarding
paths between two routers for protocols, such as routing protocols and MPLS. For more information
about BFD, see High Availability Configuration Guide.
Command
system-view
•
Method 1:
ipv6 route-static ipv6-address
prefix-length { interface-type
interface-number [ next-hop-address ] |
next-hop-address | vpn-instance
d-vpn-instance-name next-hop-address }
[ permanent ] [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
•
Method 2:
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address
prefix-length { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] |
vpn-instance d-vpn-instance-name
next-hop-address } [ permanent ]
[ preference preference-value ] [ tag
tag-value ] [ description description-text ]
ipv6 route-static default-preference
default-preference-value
delete ipv6 [ vpn-instance
vpn-instance-name ] static-routes all
320
Remarks
N/A
By default, no IPv6
static route is
configured.
The default setting is
60.
The undo ipv6
route-static command
deletes one IPv6 static
route.