Dhcp Server Configuration; Dhcp Sever Configuration Task List - Edge-Core ES3628EA User Manual

receive the DHCP broadcast packets sent by the client, therefore no DHCP packets will
be sent to the client by the server. In this case, a DHCP relay is required to forward such
DHCP packets so that the DHCP packets exchange can be completed between the
DHCP client and server.
ES3628EA switch can act as both a DHCP server and a DHCP relay. DHCP server
supports not only dynamic IP address assignment, but also manual IP address binding
(i.e. specify a specific IP address to a specified MAC address or specified device ID over
a long period. The differences and relations between dynamic IP address allocation and
manual IP address binding are:
1) IP address obtained dynamically can be different every time; manually bound IP
address will be the same all the time.
2) The lease period of IP address obtained dynamically is the same as the lease
period of the address pool, and is limited; the lease of manually bound IP address is
theoretically endless.
3) Dynamically allocated address cannot be bound manually.
4) Dynamic DHCP address pool can inherit the network configuration parameters of
the dynamic DHCP address pool of the related segment.

10.2 DHCP Server Configuration

10.2.1 DHCP Sever Configuration Task List

1. Enable/Disable DHCP server
2. Configure DHCP Address pool
(1) Create/Delete DHCP Address pool
(2) Configure DHCP address pool parameters
(3) Configure manual DHCP address pool parameters
3. Enable logging for address conflicts
1. Enable/Disable DHCP server
Command
Global Mode
service dhcp
no service dhcp
2. Configure DHCP Address pool
(1) Create/Delete DHCP Address pool
Command
Explanation
Enables DHCP server
Explanation
284