Loopback Interface - Dell PowerConnect 7000 Series Reference Manual

Command
traceroute ipv6
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.

Loopback Interface

Command
interface loopback
show interface loopback
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Multicast
Command
ip mcast boundary
ip mroute
ip multicast
ip multicast ttl-threshold
ip pim
ip pim bsr-border
ip pim bsr-candidate
ip pim dense
128
Command Groups
Description
Discovers the routes that packets actually
take when traveling to their destination
through the network on a hop-by-hop basis.
Description
Enters the Interface Loopback configuration
mode.
Displays information about configured
loopback interfaces.
Description
Adds an administrative scope multicast
boundary.
Creates a static multicast route for a source
range.
Sets the administrative mode of the IP
multicast forwarder in the router to active.
ttlvalue
Applies a
Administratively configures PIM mode for IP
multicast routing on a VLAN interface.
Administratively disables bootstrap router
(BSR) messages from being sent or received
through an interface.
Configures the router to advertise itself as a
bootstrap router (BSR).
Administratively configures PIM dense mode
for IP multicast routing.
to a routing interface.
a
Mode
PE
a
Mode
GC
PE
a
Mode
IC
GC
GC
IC
IC
IC
GC
GC