External Line Settings - Siemens hipath 1100 Service Manual

Configuring the System Specifically for the Client
Comments about the System's Programming Codes
Country/Group of Countries (65)
Specifies the country where the system will be used, configuring regional settings
accordingly.
After Country settings are configured, the system is restarted.
Attendant Console (50)
This streamlines the flow of calls to one console equipped with a system telephone
with a display.
The Attendant Console does not receive "Direct message to the speakerphone" and
it must not belong to any Executive/Secretary group.
Warning Tone for Calls without LCR (092)
This feature alerts the user to the fact that the HiPath 1100 is making a call that may
be charged by the Carrier at a higher rate than usual. This may be due to the unavail-
ability of an external line for LCR (Least Cost Routing).
When using a standard telephone, a warning tone indicates to the user that a differ-
ent carrier is completing the call at this time. When using a system telephone, the
carrier's name will show on the display.
In order to use this feature the HiPath 1100 must have been enabled for LCR (pro-
grammed via the HiPath 1100).

7.2.2 External line settings

Group of External Lines (56)
Allows you to configure the access to an external line or a group of external lines us-
ing the access code "0" or another than.
Seizure priority by type of external line (94)
This setting specifies which type of external line will be seized when making an out-
going call.
External lines can be accessed using the access code "0" or the code specified for
a group of lines.
If the PABX has digital and analog lines, you can specify which type of line will have
priority.
7-24
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual