Figure 4-26 Installing Power Supplies On The Hipath 1190/1190R - Siemens hipath 1100 Service Manual

For internal distribution only
On the HiPath 1190/1190R
●
Step
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 4-26
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Procedure
Check network voltage
Remove the system's back cover.
If the voltage is within the power supply's range, insert the power supply
into the slots shown in Figure 4-26.
Plug the system's AC cord into the AC input on the power supply (see Fig-
ure 3-30).
Connect to the backplane.
Reassemble the entire set.
"Performing a Visual Inspection" on page 4-48
To turn on the system use the switch located on the back of the cabinet
(see Figure 4-12).
Configure the required data (see "Operation" on page 6-1).
Installing power supplies on the HiPath 1190/1190R
Installation of Expansion and Option Modules
Installation
4-31