Siemens hipath 1100 Service Manual page 232

Configuring the System Specifically for the Client
Comments about the System's Programming Codes
Extension only: Each port will decrease the number of extension slots by 1. The con-
nection must be a S0 Bus line. If it has been previously configured as PP or PMP , the
connection will automatically be reversed to S0 Bus line.
After completing the configuration, the system must be restarted.
Mode of Operation (90)
This setting specifies the type of connection, either Point-to-Point, Point-to-Multi-
point, or S
With the HiPath 1120, the S0 module's first port can only be a trunk, PP or PMP . It
cannot be programmed as a S0 Bus.
With other PABXs, the first port may also be configured as a S0 Bus.
Symmetric Call (074)
This setting configures the system for symmetric calls.
Check with your local carrier to know which operating mode should be configured for
your system.
Absence of ACK Setup for external ISDN Line (075)
Check with your local carrier to know which operating mode should be configured for
your system.
Notify (076)
Check with your local carrier to know which operating mode should be configured for
your system.
Automatic Keypad (077)
Your local carrier can inform you which ISDN features can be controlled by code in
your country.
This feature allows you to activate the appropriate ISDN function at the terminal, with-
out the need for external access.
7-48
Bus) between the S
0
module and the local carrier's lines.
0
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual