Siemens hipath 1100 Service Manual page 158

Operation
Starting the Programming Mode
CommServer (installs automatically).
●
6. After installation of each component, a message is displayed indicating that the
installation was successfully completed. Select "Finish" to complete the instal-
lation.
7 . Select "Close" to close the installation window. Installation is then completed
and the computer has to be restarted.
8. Following the boot sequence, configure the CommServer. Right-click the Com-
mServer icon on the Windows status bar and select Properties. Specify these
settings:
Type of connection: ISDN connection
●
Phone #: ---
●
Your MSN: ---
●
9. When a HiPath 1100 application is activated, the server starts automatically.
V.24 Serial Interface
For this option, only the HiPath 1100 applications are installed. After restarting the
computer configure the settings on the CommServer.
Procedure:
1. Check whether the HiPath 1100 system is turned on and the computer has re-
started.
2. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Start menu on Windows, click Run and
then select the Browse button in the dialog box. Open the file SETUP .EXE on the
CD drive.
3. In the Setup window, select the language you want to use
4. Click "Install. "
A window will appear where you can select the software to be installed
5. Install your selected software components sequentially. For programming the Hi-
Path 1100 system, the following applications must be installed:
HiPath 1100 Manager E
●
CommServer (installs automatically).
●
6. After installation of each component, a message is displayed indicating that the
installation was successfully completed. Select "Finish" to complete the instal-
lation.
7 . Select "Close" to close the installation window. Installation is then completed
and the computer has to be restarted.
6-6
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual