Siemens hipath 1100 Service Manual page 235

For internal distribution only
Sensor Function Configuration (70)
Allows you to select a function for the sensor:
Deactivate the sensor's function (default)
●
Dial the number specified in "Number Dialed by Sensor Activation" (Code 052).
●
Activate the relay through the sensor
●
Detect DTMF code. When this setting is selected, the number that was called
●
must acknowledge or ignore an alarm call by sending an acknowledgement code
("#" DTMF signal)
Sensor Activation Logic (74)
The main position of the sensor can be set as follows: contacts are closed and the
sensor is activated when the contacts are open; or contacts are open and the sensor
is activated when the contacts are closed.
Time between Attempts for Activating the Sensor (050)
This setting specifies a timeout after which a new attempt is made to call an internal
or external number, assuming that the line was busy on the previous attempt.
MSN Assignment for the Sensor (051)
This settings specifies an MSN for the system. This MSN will be used for outgoing
calls. By using this MSN the called party is able to identify the origin of the call. For
instance, this would be the case for an alarm.
Number Dialed by Sensor Activation (052)
This setting specifies the number to be automatically dialed when a specific sensor
is activated. The number to be dialed when the sensor is activated is stored in the
System Speed Dialing. When the number stored in the System Speed Dialing is
changed, this field is updated. Similarly, when the number in the field is changed, the
change is reflected in the System Speed Dialing.
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Configuring the System Specifically for the Client
Comments about the System's Programming Codes
7-51