Figure 6-2 External Analog Modem Connection - Siemens hipath 1100 Service Manual

Operation
Starting the Programming Mode
External Analog Modem
For this option, only the HiPath 1100 applications are installed. After restarting the
computer configure the settings on CommServer, HiPath 1100 Manager and the Hi-
Path 1100 system.
Procedure:
1. Use the Analog Modem ( preferably US Robotics) as follows:
Figure 6-2
2. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Start menu on Windows, click Run and
then select the Browse button in the dialog box. Open the file SETUP .EXE on the
CD drive.
3. In the Setup window, select the language you want to use
4. Click "Install. "
A window will appear where you can select the software to be installed
5. Install your selected software components sequentially. For programming the Hi-
Path 1100 system, the following applications must be installed:
HiPath 1100 Manager e
●
CommServer (installs automatically).
●
6. After installation of each component, a message is displayed indicating that the
installation was successfully completed. Select "Finish" to complete the instal-
lation.
7 . Select "Close" to close the installation window. Installation is then completed
and the computer has to be restarted.
6-8
External analog modem connection
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual