For internal distribution only
Waiting 5 seconds after entering the setting.
●
If no code or setting is entered, the system will continue to wait for an entry or will
assume that a "null entry" occurred. It will proceed to the next programming step ac-
cording to the code first entered.
After a setting is programmed, the display will return to the initial state of the Pro-
gramming Mode. To exit Programming Mode simply replace the handset.
Issues Concerning Changes to the Default Password
Access to the system's Programming Mode is protected by password to prevent un-
authorized access.
To change the default password (31994) you must enter Programming Mode:
Programming Extension: * 95 +31994 + 80 + (XXXX (new password) + XXXXX
●
(confirm new password)
Make a note of the new password and store it in a safe place.
●
If you forget your password, you can use the following code sequence to regain ac-
cess for programming:
This information should not be made available to the user.
6.3.2 Programming with a Computer
The system CD contains the software packages required for installation (see "HiPath
1100 Applications" on page 6-25).
Follow these steps when programming with a computer:
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
# + 95 + 31994431.
●
Topic
Basic Requirement:
Software Installation
Software Uninstall
Starting the Programming Mode
Page
page 6-4
page 6-4
page 6-24
Operation
6-3