Siemens hipath 1100 Service Manual page 214

Configuring the System Specifically for the Client
Comments about the System's Programming Codes
Within the system, Override has the same limitation as the Silent Monitoring and
Conference features. A maximum of 2 simultaneous Silent Monitoring is allowed by
the system. Important: The Override feature is ticketed as a Conference.
Silent Monitoring (046)
This setting specifies the extension for performing Overrides without a beep.
Within the system, Silent Monitoring has the same limitation as the Conference and
Override features. A maximum of 2 simultaneous conferences is allowed by the sys-
tem. Important: The Override feature is ticketed as a Conference.
If the monitoring or the monitored party change status, Silent Monitoring will be can-
celed. This occurs, for example, when a call is placed on hold.
Only for Brazil and India
Caller ID for analog extension (CLIP) (010)
When this feature is enabled and the extension receives an incoming call, the DTMF
generator will send a signal and display the callers information at the extension.
When a E805C (Brazil) or a Gigaset 4010 telephone is used, the Caller ID information
is shown on the display.
Electronic Lock Password Reset (26)
It blocks the extension from making external calls allowing only internal calls or dialing
a number directly from the Phonebook. A 5 digit password is used for configuring this
setting.
Timeout when there is no answer (30)
This setting specifies the time duration for external calls to ring at an extension before
being transferred to a second DID, in case that there is no answer.
Dialing Mode (68)
This setting specifies the dialing mode to be used by each extension or whether the
dialing mode should be detected automatically. The dialing modes are: pulse (DP) and
tone (MF).
Flash Detection Time (31)
The Flash signal generated by a Standard MF telephone will only be detected if it is
within the range configured for the system.
Therefore, it is recommended that you check the Flash detection time of MF tele-
phones and adjust the settings to approximate them as much as possible.
The configurations for detection of Flash may vary depending on the country.
7-30
For internal distribution only
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual