Siemens hipath 1100 Service Manual page 233

For internal distribution only
Assignment of an external ISDN line to a MSN (078)
This features allows you to assign the MSNs provided by your local carrier to calls
made to ISDN lines.
By default, all ISDN lines are assigned to MSNs.
External Line Prefix (89)
This setting specifies the prefix for the PABX external lines, for domestic and interna-
tional calls. By default, the type of a programmed called is not specified.
External Number Registration (91)
To use the Attendant feature each external number must be registered to a specific
slot.
If the prefix (Code 089) for these numbers has already been configured, only the final
digits need to be registered.
By default, no digits are specified.
Assignment of an External Number to an Extension (92)
With this code the external numbers registered in each slot are assigned to exten-
sions or Subscriber Groups designated to answer external calls made to those num-
bers. An extension cannot be assigned more than once.
Busy Signaling (004)
This signals the caller that the line is busy, when the system receives an incoming
call and the attendant extension is busy.
This feature is valid only for digital lines with an attendant number. It is not valid if
more than one extension is configured for the slot/DID number/MSN. If the Fax/DID
module is installed and configured for digital lines, this feature will also be invalid.
Local Area Code Filter (011)
This allows the system to send the Area Code (LAC) to a destination exchange over
a digital line. This enables Caller ID.
Country Area Code Filter (012)
This allows the system to send the Country Code (CAC) to a destination exchange
over a digital line. This enables Caller ID.
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Configuring the System Specifically for the Client
Comments about the System's Programming Codes
7-49