Siemens hipath 1100 Service Manual page 236

Configuring the System Specifically for the Client
Comments about the System's Programming Codes
Number of Attempts for Activating the Sensor (053)
This setting specifies the number of call attempts (between 1 and 100) for the num-
ber specified in "
tween Attempts for Activating the Sensor
An attempt is made after every call that was not answered (busy signal), or when the
"Detect DTMF Code" option (Code 70, Option 3) is enabled and no acknowledgment
is received. When this occurs, the call is disconnected and a new attempt is made.
Relay (75)
This setting specifies the operating mode for the relay:
"Switch" The relay can only be turned on from an extension by entering the
●
proper feature code (see Miscellaneous Functions - Relay in the User Manual).
"Monoflop": The relay is closed for a specified length of time. Alternatively, the
●
relay can also be opened before the set time by entering the proper feature code
(see Miscellaneous Functions - Relay in the User Manual).
"Invert": The current state of the Relay is reversed when the feature code for ac-
●
tivating it is selected at an extension.
"Music on Hold" The Relay can be used for activating external equipment con-
●
nected for playing announcements/music.
"External signal" It is possible to use the Relay to control a second ring for an ex-
●
tension.
Timer for Deactivating the Relay (73)
Specifies the length of time that the relay must remain closed.
If the closing time is set to "000," the relay will remain active until it is manually de-
activated.
External Ring for Activating the Relay (071)
This setting lets you use the relay to control a second ring signal for a specified ex-
tension.
7-52
Number Dialed by Sensor Activation
For internal distribution only
. " (See also
).
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Time be-