Siemens hipath 1100 Service Manual page 225

For internal distribution only
Remote Operation Mode (084)
This specifies the remote updating of the software.
An update can be carried out remotely over external digital ISDN lines and analog
lines connected to a modem.
Remote Administration Activation (066)
This setting allows the system to be administered remotely.
External Number Configuration (067)
This specifies external numbers (Service MSN without external access code 0) that
are able to perform Remote Administration.
Remote Administration Password (068)
This specifies a password (5 digits) for enabling Remote Administration from an ex-
ternal number (Service MSN).
Remote MSN (069)
This setting specifies an ISDN line MSN as the Remote MSN.
The system will only allow Remote Administration when this remote MSN is used.
Without MSN Verification (070)
Remote Administration will be performed without verifying the Service MSN that has
been transmitted.
Remote Administration via DTMF (57)
Allows you to configure the system remotely using a Standard MF telephone.
Remote configuration:
●
Remote Configuration must be enabled and the programming extension must
have a conversation in progress on the external line over which programming is
to be performed.
In Talk mode enter the code (*991) at the programming extension to transfer
control of the HiPath 1100 to the remote programmer. The remote programmer
must then enter the system password using a MF telephone.
To execute the required programming proceed as if the remote telephone was
connected directly to the system.
If there is a Fax/DID module available:
●
Enter the code (* 95) using the remote MF telephone after answering the call.
The remote programmer must then enter the system password using a MF tele-
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
Configuring the System Specifically for the Client
Comments about the System's Programming Codes
7-41