Siemens hipath 1100 Service Manual page 166

Operation
Starting the Programming Mode
4. Double-click to run the following file: CAPI_HiPath 1000_XXX.exe. In the corre-
sponding window, use "Browse" to choose the installation path for decompress-
ing "Call-Bridge for Data" (e.g., the temporary folder and C:\Temp) then decom-
press the file using "Decompress. "
Proceed with the installation which matches your operating system:
Next, install the CAPI applications.
Windows 98 SE
Additional system components may need to be installed during driver installation.
So please have the Windows 98 CD available.
1. The Add New Hardware Wizard window appears. A message will appear indicat-
ing that Setup will search for new Composite USB device drivers. Click "Next" to
proceed.
2. Select the option "Search for the best driver for your device" and click "Next."
3. Select the "Specify a location:" checkbox and click "Browse" to select the direc-
tory where the uncompressed CallBridge for Data is stored (e.g., C:\Temp). Click
"Next" to proceed.
Figure 6-6
4. A message will appear indicating that the best driver for the hardware has been
found.
Click "Next" to proceed.
5. A message appears confirming that the Composite USB device installation was
completed. Click "Finish."
6-14
Operating System
Windows 98 SE
Windows ME
Windows 2000
Windows XP
Windows 98 SE - USB/CAPI driver installation location
For internal distribution only
page 6-14
page 6-16
page 6-18
page 6-20
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual