Table of Contents
Advertisement
2 Install Door Position Switch (DPS)
Wood doors have 3/8" raceway to controller cutout and metal doors
have 3/4" raceway to the controller cutout.
Refer to template A7951.
1. Insert connector end of DPS through the raceway
on the latch edge of the door (Fig. 2A).
Note: For metal doors, use DPS Collar.
2. Push DPS firmly into place by hand.
: DO NOT TAP SWITCH WITH ANY TOOL.
IMPORTANT
Dim 1
Dim 2
(From template)
Horizontal
of Strike
3 Position Exit Trim (ET)
1. Slide mortise lock into door and loosely secure with (2) flat head screws.
Note: For exterior applications, use ET gasket (52-0263) to seal between ET trim and
the door surface.
2. For wood doors: Route ET wire harness through
the wire cutout, out the other side and through
the Wire Run Channel (on
the inside) to the Controller Cutout.
For metal doors: Route ET wire harness
through the wire cutout and door and
out the controller cutout.
3. Position the ET trim so the ET spindle
engages the mortise lock hub
and hold in place.
1-800-810-WIRE • www.sargentlock.com • A8034G
Door Position
Switch Hole
Vertical
of Strike
Dim 1
Fig. 2B
ET Control
ET Control
Outside of Door
22
Passport 1000 P1 Exit Device
Collar is used only
with metal doors.
Door Position
Switch (DPS)
Wood Frame
Metal Frame
3/8"
3/4"
Fig. 3
Inside of Door
Fig. 2A
Wire Harness
(From motor)
(2) 1/4" x 2-3/8"
Flat Head
Machine Screws
(Secures ET)
Mortise Lock Body
Advertisement
Table of Contents
