Sargent PASSPORT 1000 Exit Device Installation Instructions Manual page 25

Passport 1000 P1 Exit Device
8 Install Wire Cover (Wood Doors Only)
1. Position the wire cover plate above the
chassis cover and covering the wire channel.
Mark hole positions.
Note: Make sure stamped side of plate is against door.
2. Drill (2) 3/32" diameter by 1/2" deep holes (Fig. 8A).
3. Cover wires with cover plate by securing plate
to door directly above chassis (note orientation)
using two (2) #6 x 1/2" flat head security
torx wood screws (Fig. 8B).
Note: Position lower edge of cover plate against the
cover to ensure that no wires are visible.
Back Side of
Wire Cover Plate
This Side Down
9 Install Outside Escutcheon (with Optional Gasket)
Note: Gasket optional, for non-fire rated doors only.
For non-fire rated door applications, an optional gasket
(Part number 52-0782) may be used as a weather seal
between the escutcheon and the outside door surface.
Peel off adhesive backing and attach to (outside) escutcheon.
1. Position the outside escutcheon, aligning the posts with
the door prep (Fig. 9).
2. On the inside of the door, position the mounting plate
over the indicated holes.
3. Feed reader cable through opening.
(2) 3/32" Diameter by
Fig. 8B Detail
1/2" Deep Holes
Fig. 8A
25 1-800-810-WIRE • www.sargentlock.com • A8034G
Inside of Door
Wire Cover
(2) #6 x 1/2"
Flat Head Security
Torx Wood Screws
Fig. 9