Lock Installation - Sargent ASSA ABLOY IN100 Series Installation Instructions Manual

6

Lock Installation

2A Prepare 7900 Lock Body*
*If 7900 is type of lock being installed
1. Reverse Lock Hand (If Required)
Red surface of locking piece must face the out-
side/locked side of door.
To rotate locking piece (Fig. 2A1):
a. Position lock body with red surface of
locking piece visible.
b. Insert slotted screwdriver into locking piece slot
to rotate locking piece toward
back of lock body.
c. Rotate the locking piece 180° until
RED surface is on opposite side.
Note: Red indicates locked side (outside).
2. Reverse Latch Hand (If Required)
a. Rotate the latchbolt 180° (Fig. 2A2).
b. Flip deadlatch by hand to match bevel of latchbolt.
3. Configure the DIP Switch Settings
IMPORTANT:
This product is built and factory tested to the configuration
specified. Any change to the DIP-switch settings located at
the bottom of the mortise lock body must be made prior to
lock installation.
NOTE: Gray bar indicates LH & LHR setting
Fig. 2A1
Latchbolt
Deadlatch
Fig. 2A2
Fig. 2A3
8 1-800-810-WIRE • www.sargentlock.com • A8190E
IN100 Series
Mortise Lock
Installation Instructions
Locking piece
Locking piece
Handing
LH & LHR
RH & RHR