Sargent PASSPORT 1000 Exit Device Installation Instructions Manual page 8

Installation Wiring (Continued)
PoE Door Harness
C
Order of installation may vary. Refer to appropriate sections for instructions.
Hinge-side harness connectors:
• 4-pin male Molex connector
• 6-pin male Molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• Male RJ45 connector (crimped after cable is fed through door)
Notes:
• Connectors go on only one way. They cannot be plugged to incorrect position.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
4-pin F
6-pin F
PoE Lock
D
Order of installation may vary. Refer to appropriate sections for instructions.
1. Prop door open.
2. Using the ring terminal, carefully route the assembly through the door
channel to the lock.
1-800-810-WIRE • www.sargentlock.com • A8034G
PoE Hinge
4-pin F 4-pin M
6-pin F 6-pin M
Passport 1000 P1 Exit Device
PoE Door Harness
Cable
Drain Wire
: CAT 5e,
26 AWG stranded,
100ohm
8
PoE Lock
RJ45-M
PoE
Harness
(Cat 5e)