13 Install Inside Escutcheon
1. Position inside escutcheon as shown (Fig. 13).
Verify that all wires are positioned within the escutcheon
to avoid pinching.
2. Attach escutcheon with (2) #8-32 x 1/2" T-20 Torx pan
head screws.
3. Straighten escutcheon and tighten securely.
DO NOT OVERTIGHTEN.
14 Installation of Rail Assembly
1. Retrieve harness from end of rail. Harness has limited
travel and can be damaged.
2. Attach harness to female connector on chassis.
3. Install rail and screws per exit device instructions.
Note: This view shows rim exit device version
1-800-810-WIRE • www.sargentlock.com • A8034G
Passport 1000 P1 Exit Device
Fig. 13
Fig. 14
20
(2) #8-32 x 1/2"
Torx Screws