Table of Contents
Advertisement
7800 and 8200 Series Mortise Lock
Used with Sectional Trim and V Series Indicators
Installation Instructions
5
Installation
a
Prepare Door for Mortise Lock
Prepare door for function holes, size, and location
according to A7050 door marker template,
if not already prepped.
b
Install Lock
1. Verify strike location according to template.
Clean out door pocket and door edge of debris.
2. Make sure handing of lock matches handing of door.
Slide lock into door. (Figure 6)
3. Temporarily hand tighten two (2) lock screws
(#12 x 1-1/4" wood screws, or #12-24 x
1/2" machine screws).
Notes:
• Keep door open until installation is complete.
• If installing lever onto only one (1) side of door (36 function), see separate instruction sheet A7028.
c
Prepare Door for Indicator
1. Insert template guide into control hub on
side where indicator will be used. (Figure 7)
2. Slide indicator template over template
guide.
Important: Make sure the template
is properly centered and aligned to
ensure smooth indicator operation.
3. Mark the four (4) hole positions
indicated on template.
4. Remove guide and template.
5. If indicators are being used on both sides
of door, repeat steps 1 through 4 for opposite side.
6. Remove lock body.
7. Drill four (4) marked holes with 3/32" diameter bit, by 1/2" deep.
8. Reinstall lock body and hand tighten screws.
Note:
If retrofitting over an existing product, ensure door surface is free of chips and
debris around holes so indicator will sit flat against door surface.
1-800-727-5477 • www.sargentlock.com
Copyright© 2019, 2020 SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
Inside of door
Lock Screws
Lock
Figure 6
Control Hub
Guide
Template
Figure 7
4
Outside
of door
RH door
shown
Mark holes
with pencil
A8257C 03/20
Advertisement
Table of Contents
