Installation Instructions - Sargent Profile Series Installation Instructions Manual

Profile Series v. S1 Cylindrical Lock
6

Installation Instructions

1. Verify Hand and Bevel of Door
Stand on outside/locked side of the door when determining the door hand
2. Door Preparation
Prepare door according to appropriate template
(see website www.sargentlock.com):
• For metal door template, see 4531 and 4532
• For wood door template, see A7456, A6719D and 4540A
• Prior to installation, all holes must be free of burrs, debris
and sharp edges
• If doors are not properly reinforced per ANSI115.2,
commercially available reinforcements
should be installed
Hole for ribbon
cable from keypad
to controller
Lockbody
hole
Inside
of door
4
Latchbolt
door prep
Pre-drilled
and/or tapped
holes 2 places
Wood Door Preparation
For installation assistance, contact SARGENT at 800-810-WIRE (9473)
7/8"
C L of
1-1/2" Dia.
1-1/2"
Outside
of door
(2) 1/8" Dia. holes
required
Through-bolt
hole (2)