Table of Contents
Advertisement
Passport 1000 P1 Exit Device
Installation Wiring (Continued)
Frame Harness Installation
A
Supplied by CI
B-Splice
Crimp Connector
RJ45-M
Ceiling
24AWG
Stranded
Wire for
Earth
Ground
inside
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable
drain wire
concealed
in shrink
Molex-M
tubing
PoE Data Hinge
B
Frame
4-pin M
6-pin M
6-pin F
Components and wire harness supplied by McKinney, Suggested installation:
Cut end / ceiling-side PoE harness:
NOTE: TIA/EIA 568-B added
only at lock side
Do not confuse pair numbers with pin numbers. A pair number is used for refer-
ence only (eg: 10Base-T Ethernet uses pairs 2 & 3). The pin numbers indicate
actual physical locations on the plug and jack.
Hinge side of PoE harness:
1. Feed cut end of harness into hole on hinge-side through single access hole.
2. Push one connector back through the hole and feed into the other access hole.
Each of the hinge-side harness connectors should end up threaded through
a different access hole and matched to the same size pin connector from
the door harness:
• 4-pin male molex connector.
• 6-pin male molex connector with ground wire.
4-pin F
PoE Hinge
TIA/EIB-568-B Standard Wiring
pin
pin
1
8
8
4-pin F
Hinge-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
Lock-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
7
1-800-810-WIRE • www.sargentlock.com • A8034G
PIN
Wire
1
1
White/Orange
2
Orange
3
White/Green
4
Blue
5
White/Blue
6
Green
7
White/Brown
8
Brown
Pair
Number
2
2
3
1
1
3
4
4
Advertisement
Table of Contents
