Chassis Cover - Sargent PASSPORT 1000 Exit Device Installation Instructions Manual

8 Install Chassis Cover
Secure chassis cover to chassis using
(4) #8-32 x 5/16" oval head machine
screws (Fig. 8).
9 Install Wire Cover (Wood Doors Only)
1. Position the wire cover plate above the
chassis cover and covering the wire channel.
Mark hole positions.
Note: Make sure stamped side of plate is against door.
2. Drill (2) 3/32" diameter by 1/2" deep holes (Fig. 9A).
3. Cover wires with cover plate by securing plate to
door directly above chassis (note orientation) using
two (2) #6 x 1/2" flat head security torx wood screws
(Fig. 9B).
Note: Position lower edge of cover plate against the
cover to ensure that no wires are visible.
Wire Cover Plate
This Side Down
1-800-810-WIRE • www.sargentlock.com • A8034G
Back Side of
Fig. 9B Detail
Passport 1000 P1 Exit Device
Fig. 8
(2) 3/32" Diameter by
1/2" Deep Holes
16
Inside of door
Wire Cover
(2) #6 x 1/2" Flat
Head Security
Torx Wood Screws
Fig. 9A