6 Install Cylinder
For devices without cylinder, go to Step 7.
1. Slide cylinder through ET Trim and thread into
the lockbody, rotating the cylinder clockwise.
Cylinder should rest flush on ET Case.
Note: SARGENT logo must be horizontal
and on the top of the cylinder (Fig. 6B).
2. Secure the cylinder by tightening cylinder clamp
screw located above the guardbolt.
3. Verify that the key retracts the latchbolt.
Position cylinder so that the SAR-
GENT logo is right-side up.
Correct
7 Install Chassis Cover
Secure chassis cover to chassis using
(4) #8-32 x 5/16" oval head machine screws.
Inside of Door
1-800-810-WIRE • www.sargentlock.com • A8034G
Incorrect
Fig. 6B
Fig. 7
Passport 1000 P1 Exit Device
Outside of Door
#46 Cylinder
Fig. 6A
Chassis Cover
24
(4) #8-32 x 5/8" Oval
Head Machine Screws
Set Screw