Sargent PASSPORT 1000 Exit Device Installation Instructions Manual page 28

12 Installation of Inside Module Component Assembly
1. Insert top tabs of controller into slots on mounting plate (Fig. 12A, B).
2. Ensure proper alignment of board-to-board connectors while pivoting bottom
of controller toward door until tab on bottom snaps securely into place on
mounting plate.
CAUTION: To avoid possible damage to board-to-board connectors,
care should be taken when securing controller to mounting
plate. If there is resistance when securing, detach controller
to determine cause before re-attaching controller.
3. Connect RJ45 male Connector to female RJ45 on
controller board (Fig. 12B).
1-800-810-WIRE • www.sargentlock.com • A8034G
Fig. 12A
Passport 1000 P1 Exit Device
4. Remove pull tab from its
position beneath the coin cell
by pulling on tab in direction of
arrows printed on tab (Fig. 12B).
28
Fig. 12B