Sargent PASSPORT 1000 Exit Device Installation Instructions Manual page 13

Passport 1000 P1 Exit Device
2 Install Door Position Switch (DPS)
Wood doors have 3/8" raceway to controller cutout and metal doors
have 3/4" raceway to the controller cutout.
Refer to template A7951.
1. Insert connector end of DPS through the raceway on the latch edge of
the door (Fig. 2A).
Note: For metal doors, use DPS Collar.
2. Push DPS firmly into place by hand.
: DO NOT TAP SWITCH WITH ANY TOOL.
IMPORTANT
Dim 1
Dim 2
(From template)
Horizontal
of Strike
3 Position Exit Trim (ET)
For exterior applications, use ET gasket (52-0263) to seal
between ET escutcheon and outside door surface.
1. For wood doors: Route ET wire harness through the cylinder hole,
out the other side, and through the wire run channel to the
controller cutout.
For metal doors: Route ET wire harness
through the cylinder hole and door
and out the controller cutout.
2. Position and hold ET trim on the door.
Door Position
Switch Hole
Vertical
of Strike
Dim 1
Fig. 2B
Collar is used only
with metal doors.
Door Position
Switch (DPS)
Wood Frame Metal Frame
3/8" 3/4"
ET Gasket
(Exterior Applications)
ET Control
13 1-800-810-WIRE • www.sargentlock.com • A8034G
Inside of Door
Fig. 2A
Outside of Door
ET Wire
Harness
(from motor)
Fig. 3