Installation Instructions - Sargent ASSA ABLOY SE LP10 Installation Instructions Manual

Installation Instructions

7
1 Door Preparation
A. Verify Hand and Bevel of Door
Stand on outside of locked door when determining door hand.
Left Hand
Hinges Left.
Open Inward.
"LH"
B. Door Preparation
Prepare door according to appropriate template. If necessary, refer to website
www.intelligentopenings.com.
Instructions show wood door, with cable channel on inside for wires. For metal door, route wires
inside door.
• Prior to installation, make sure all holes are free of burrs, debris, and sharp edges.
• If doors are not properly reinforced per ANSI 115.2, commercially available reinforcements should
be installed.
• Templates:
• Door Manufacturer's Template: 4703
• Field Template: A8124
• Outside Field Prep Template: A8129
Outside of
Door
Raceway for Power and
Access Control
Hole for Reader and
ElectroLynx cables
Pre-drill Holes
(2 places)
Lock Body Hole
Left Hand Right Hand
Reverse Bevel Hinges Right.
Hinges Left. Open Inward.
Open Outward. "RH"
"LHRB" Fig. 1A
Fig. 1B Wood Door Shown
12 A8117G • 800-810-WIRE (9473) • www.sargentlock.com
SE LP10 Cylindrical Lock
Right Hand
Reverse Bevel
Hinges Right.
Open Outward.
"RHRB"
Inside of
Door
Raceway for Power and
Access Control
Hole for Reader and
ElectroLynx cables
Pre-drill Holes
(4 places)
Through-bolt Holes